永信贵宾会app欢迎您(中国)有限公司

7*24Hours for you

15967710202/0577-66081118

company newsCurrent Pocation:homecompany news

What are the requirements of polyurethane foaming machine for polyurethane base

As polyurethane contains strong polar carbamate groups, it can be divided into two types according to its molecular structure: linear type and body type. Due to the different cross-linking density, the structure can be hard, soft or between the two properties, with high strength, high wear resistance and solvent resistance. So what are the basic requirements of polyurethane foaming machine for polyurethane?

1. All pipe fittings, sanitary equipment, floor drain or water outlet must be installed firmly, with tight joints and round end, without any loose phenomenon.

2. Before construction, remove the protrusions, mortar bumps and other foreign matters on the surface of the base layer with spade knife and broom, and thoroughly clean the dirt and sundries. For Yin and Yang Angle, pipe root, floor drain and drain mouth and other parts should be carefully cleaned, such as found oil, rust, to use wire brush


3. The waterproof base of polyurethane shall be wiped with 1:3 cement mortar to make 1/50 flood slope according to the design requirements, and its surface shall be smoothed and compressed, and uneven, loose, sand-removing and other defects shall not be allowed. Drains or floor drains should be lower than the entire waterproof layer, in order to remove water. The pipe position with casing should be more than 20mm above the base surface. The Angle of Yin and Yang should be made into a small round corner with a radius of 10mm, so as to facilitate the coating construction.

4. The construction, in construction of traditional polyurethane waterproof coating, waterproof base should be basic in dry state, it is advisable to moisture content is less than 9%, the simple determination method is the area of 1 ㎡, thickness of 1.5 ~ 2.0 mm rubber cover on the base, place 2 ~ 3 hours, such as the coverage of the surface of the base without the watermark, close to the primary side rubber sheet and no condensation watermark, according to the experience shows that the moisture content is less than 9%, conform to the requirements of the construction.


永信贵宾会app欢迎您|永信贵宾会app欢迎您

XML 地图 | Sitemap 地图